Epson ES-300C Produkt-Support-Bulletin - Seite 6

Blättern Sie online oder laden Sie pdf Produkt-Support-Bulletin für Software Epson ES-300C herunter. Epson ES-300C 13 Seiten. Laser & non-impact printer error codes
Auch für Epson ES-300C: Produkt-Support-Bulletin (19 seiten), Handbuch (8 seiten), Ergänzendes Handbuch (15 seiten), Handbuch (11 seiten), Produkt-Support-Bulletin (20 seiten), Produkt-Support-Bulletin (14 seiten), Produkt-Support-Bulletin (25 seiten)

Seite drucken

[S] PROCESSING

The printer is processing data.

[S] QUIT THE JOB

The On-Line button has been pressed while a print job was in progress.

job can be flushed by pressing the Reset button, or a reset can be cancelled

by pressing any other button.

[S] QUITTING THE JOB

The printer is flushing a job from the buffer.

[S] READY

The printer is ready to receive data.

[S] RESETTING

This message appears initially when the printer is turned on, and

momentarily between print jobs.

[E] TONER LOW

The imaging cartridge must be replaced.

[S] WAIT FOR READY

The On-Line button was pressed while a print job was in progress.

printer continues printing until the current job is completed, then it goes

Off-line.

[S] WAITING

The printer is in the process of executing a job and has run out of data and

is waiting for the channel to provide more data.

EPL-7000 cont.

[S] WARMING UP

The printer is warming up.

Note:

If any of the following messages appear, turn the printer off for at

least five seconds, then turn it back on.

displayed, repair is required.

SCAN MOTOR ERROR

HSYNC ERROR

HEATER LAMP ERROR

MAIN MOTOR ERROR

FAN MOTOR ERROR

------------------------------------------------------------------------------

ES300C Display Codes

E-C

Command error.

E-1

Interface error

a. Incorrect communication parameter received.

b. Broken connector or wire.

c. Host failed to respond within 30 seconds.

d. Host is not accepting data. (DSR=Low)

E-F

Fatal error

a. A lamp is broken.

b. Power is applied before the transportation screws were removed.

c. System failure

------------------------------------------------------------------------------

An unidentified command or parameter was detected.

If the same message is

The