Dimplex BLF74 Wartungshandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Wartungshandbuch für Innenkamin Dimplex BLF74 herunter. Dimplex BLF74 16 Seiten. Section 10309 manufactured electric fireplaces
Auch für Dimplex BLF74: Benutzerhandbuch (3 seiten)
Seite drucken
TROUBLESHOOTING GUIDE
PROBLEM
General
Circuit breaker trips or fuse
blows when unit is turned on
Unit turns on or off by itself
Lights dim in room while the unit
is on
Power cord gets warm
Appearance
Fireplace does not turn on Manu-
ally
Fireplace does not turn on using
the Remote Control
Flame Frozen
Flame not bright or flame not
visible
Flame Shutter
CAUSE
Short in unit wiring.
Improper circuit current rating
Remote Control has a similar frequency
to other remotes in the area.
Radio frequency disturbance from out-
side sources.
Defective Remote Control Receiver
Unit is drawing close to circuit current
rating
Normal Operation
Defective power cord
Improper operation
No incoming power from the electrical
wall socket
Loose wiring
Defective On/Off Switch
Defective Remote Switchboard
Improper operation
Remote Control not initialized to fireplace Initialize the Remote Control
Remote Control not working
Loose wiring.
Defective Flicker Motor
Defective LED Driver Board
Loose wiring
Defective LED Light Strip
Defective LED Driver Board
Defective Flicker motor
SOLUTION
Trace wiring in unit.
Additional appliances may exceed the current rating
of the circuit breaker or fuse. Plug unit into another
outlet or install unit on a dedicated 15 amp circuit.
Replace Remote Control. Initialize to Remote Control
Receiver.
Replace Remote Control and Remote Control Re-
ceiver where necessary. Initialize Remote Control and
Receiver.
Replace Remote Control Receiver. Initialize Remote
Control and Receiver.
Move the unit to another outlet or install unit on a dedi-
cated 15 amp circuit
The power cord may get slightly warm to the touch
when the heater is on
Replace power cord if cord gets too hot to touch.
Refer to Operation Section
Check fuse/breaker panel
Check wiring connections
Replace On/Off Switch
Replace Remote Switchboard
Refer to Operation Section
Install new battery into the Remote Control. Initialize
Remote Control where necessary
Replace Remote Control Receiver or Remote Control
where necessary. Initialize Remover Control and
Remote Control Receiver
Check wiring connections
Replace Flicker Motor
Replace LED Driver Board
Check wiring connections
Replace LED Light Strip
Replace LED Driver Board
Replace Flicker motor
15