Philips DCM2020 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Stereo System Philips DCM2020 herunter. Philips DCM2020 22 Seiten. Micro music system
Auch für Philips DCM2020: Schnellstart-Handbuch (2 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (21 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (23 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (22 seiten), Broschüre (3 seiten), Schnellstart-Handbuch (2 seiten), Benutzerhandbuch (21 seiten), Gebrauchsanweisung (21 seiten), Benutzerhandbuch (23 seiten)

Seite drucken
Philips DCM2020 Benutzerhandbuch

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine, or fire. Never discard batteries in fire.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
a
b
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
EN
12
c

Turn on

Press .
» The unit switches to the last selected
source.
Switch to standby mode
Press
again to switch the unit to standby
mode.
» The clock (if set) is displayed.
To switch to Eco power standby mode:
Press and hold
for more than two seconds.
» The backlight on the display panel
turns off.
To switch between normal standby mode and
Eco power standby mode:
Press and hold
for more than two seconds.
Note
•
If no button is pressed over 15 minutes in standby
mode, this device goes to Eco power standby mode
automatically.

Set clock

1
In standby mode, press and hold
PROG/CLOCK SET for more than two
seconds to activate clock setting mode.
» [CLOCK SET] (clock set) scrolls on
the display, and then the time format
[24H] and [12H] is displayed.
2
Press
/
to select 24H or 12H, and
then press PROG/CLOCK SET.
» The hour digits begin to blink.
3
Press
/
to set hour, and then press
PROG/CLOCK SET again.
» The minute digits begin to blink.
4
Press
/
to set minute.