Philips DCM2020 Руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя для Стереосистема Philips DCM2020. Philips DCM2020 22 страницы. Micro music system
Также для Philips DCM2020: Краткое руководство по эксплуатации (2 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (21 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (23 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (22 страниц), Брошюра (3 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (21 страниц), Инструкция пользователя (21 страниц), Руководство пользователя (23 страниц)

Печатать страницу
Philips DCM2020 Руководство пользователя

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine, or fire. Never discard batteries in fire.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
a
b
Note
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not use old and new or different types of batteries
in combination.
•
Batteries contain chemical substances, so they should
be disposed of properly.
EN
12
c

Turn on

Press .
» The unit switches to the last selected
source.
Switch to standby mode
Press
again to switch the unit to standby
mode.
» The clock (if set) is displayed.
To switch to Eco power standby mode:
Press and hold
for more than two seconds.
» The backlight on the display panel
turns off.
To switch between normal standby mode and
Eco power standby mode:
Press and hold
for more than two seconds.
Note
•
If no button is pressed over 15 minutes in standby
mode, this device goes to Eco power standby mode
automatically.

Set clock

1
In standby mode, press and hold
PROG/CLOCK SET for more than two
seconds to activate clock setting mode.
» [CLOCK SET] (clock set) scrolls on
the display, and then the time format
[24H] and [12H] is displayed.
2
Press
/
to select 24H or 12H, and
then press PROG/CLOCK SET.
» The hour digits begin to blink.
3
Press
/
to set hour, and then press
PROG/CLOCK SET again.
» The minute digits begin to blink.
4
Press
/
to set minute.