CRRC MS-ZD20S Handbuch für Betrieb und Wartung - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Werkzeuge CRRC MS-ZD20S herunter. CRRC MS-ZD20S 9 Seiten. Battery installation tool

Seite drucken

holding the battery tool or inserting the battery, if the fingers close to power switch and let it to open position, it

may cause accident.

d. Don't open battery, otherwise it will cause danger of short circuit. Keep the battery away from heat sources

(such as long-term solar radiation) and fire sources, if the battery closes to heat sources or fire sources, it will

explode.

e. If the battery is broken or used improperly, there will be toxic smoke, if it occurs, the injured shall take fresh

air and be hospitalized immediately.

f. If the battery is defective, it will emit fluid which contaminates nearby objects. Please check the affected part,

and clean or replace the battery if necessary.

Operation Rules of Battery Tool

5. Operation Notices of Battery Tool

a）The situation of battery tool with over-load which causes tool stuck is forbidden. Please select the proper

model of battery tool before operation.

b）The operator shall comply with the safety operation rules, if find damage on insulation wire, plug or others,

the operator shall stop using the battery tool.

c）Don't use battery tool which has defective power switch. The defective tool shall be repaired before operation

d）Before adjusting, the operator shall remove the plug and battery from socket and take out the battery pack

from the tool, and then replaces accessories.

e）When operator does not use battery tool, the battery tool shall be placed far away from children. For people

who are not familiar with the battery tool or don't read operation manual are not allow to operate. The

operator shall pay attention to regular maintenance of battery tool and carefully check whether the operation

pars are in good working condition, and simultaneously detect whether there are damaged parts or parts that

may affect the operation of the battery tool.

f） After riveting about 100 rivets, the exterior sleeve of battery tool shall be disassembled to clean metal debris,

it can improve improve the service life of the battery tool.

g）It is normal that the surface temperature of the battery tool will be higher while it's continuously working, and

the sound of internal gear will be slightly louder. We hereby suggest that the operator should stop the battery

tool for 10~15 minutes after it's continuously working for 30 minutes, and then operates it again, so that the

service life of the battery tool will be greatly improved.

6. Operation Notices of Battery

a）The operator shall use the matched charger supplied by the battery manufacturer to charge the battery.

b）The battery installation tool only accepts the matched battery. If it adopts other types of batteries, it may cause

blaze or people injured.

c）For the battery which doesn't use, the operator shall place it far away from clip, coin, nail, screw and other

small metal objects. If the battery contacts are short-circuited, it will cause blaze or people injured.

d）The operator shall avoid contacting with the liquid leaking from the battery due to improper operation,

because the leakage will burn the skin, in case the body contacts with battery fluid, washing immediately with

water.

眉山中车紧固件科技有限公司