aeolus UC-1801 Schnellstart-Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Zubehör aeolus UC-1801 herunter. aeolus UC-1801 12 Seiten. Professional vet equipments supplier

Seite drucken

Water Level

Sensor

Figure 8.3.3-c

3. Complete Cleaning and Maintenance: remove and clean parts and assemblies periodically. Desired

results are achieved only by cleaning after removal.

Steps for Disassembling Components:

Remove four screws from the master control rack on the right to take down the right master control rack,

(remove the left master control rack in the same way). See figure. 8.3.1.

Remove power connection plugs on power cords on one side of the master control rack one by one. Note

that plugs have different colors for each electrical component.

Warning: do not remove control racks or electrical components from control racks immediately after shut

down; give it some time to cool down. The heaters in control racks reach high temperature. Remove control

racks or contact heaters after a 30 minutes respite after shutdown.

Remove four screws

Take down the rack

Figure 8.3.1-a

Remove four screws in the fan box and take out the whole heater. Clean the fan. Try not to remove heat sinks

from the fan, especially PTC heater bands that cannot be removed from heat sinks. See figure. 8.3.2.

Remove and clean filters behind the square plastic section inside the chamber.

Remove four

screws of fan

PTC Heater

Fan

Figure 8.3.2-a

Figure 8.3.3-d

Temperature

Humidity sensor

Humidiﬁer

Right fan

Anion

Carbon ﬁlters

PTC Heater

Figure 8.3.1-b

PTC Heater

Fan

Figure 8.3.2-b

4. Cleaning

The ICU must be empty at the time of cleaning. Cleaning is feasible only after removal.

5. Maintenance

It is suggested to maintain the machine every two months during normal operation, which shall be carried

out in accordance with removal, installation and maintenance procedures above.

Trouble-shooting

Phenomenon

Cause analysis

After the power switch is pressed,

1.Bad power connection and

there is no reaction or the power

plug connection

indicator lamp is still off

2.Damaged switch

1.Too big atmizing particles of

solution causes little atomizing

volume

Little atomizing volume form the

2.Solution contains syrup or

medical atomizer

colloform

3.Tablets are used for

dissolution

4.Oily impurities on the surface

of solution

1.Water shortage of the

water tank of the atomizer

2.Damaged ultrasnic chip of

No atomizing form the

the atomizer

atomizer

3.Water scale in the tank of

the atomizer

Atomizing time and volume

Remaining solution not atomized

depend on concentration of

in the cup after atomization of the

atomizing liquid

medical atomizer

Solution

1. Check power connection

2.Replace the power switch

1.Too big particles are not

suitable for operation of this

atomizer

2.When solution contains syrup

or colloform,it requires with dry

filter paper

3.When tablets are used for

dissolution,dissolve sediments

to remove impurites first

4.Remove oily impurities on the

surface of solution with clean

tissue firstivvv

1.Add water into the water tank

until it is at the same level of

the cup bottom

2.Replace the ultrasonic chip

3.Gently scrub the inside of

the tank with lint

Repeat the atomization

operation procedure if not

completely atomized once