Pioneer XC-L77 Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Auto-Empfänger Pioneer XC-L77 herunter. Pioneer XC-L77 48 Seiten. Stereo cd receiver; speaker system; stereo cassette deck

Seite drucken

CAUTION

Danger of explosion if battery is incor-

rectly replaced.

Replace only with the same or

equivalent type recommended by the

manufacturer. Discard used batteries

according to the manufacturer's

instructions.

7 meters

Operating range of the remote

control unit

Checking What's in the Box

Thank you for buying this Pioneer product. Before starting to set up your new stereo

system, please check that you received the following supplied accessories in the

XC–L77 Stereo CD Receiver box:

• AM loop antenna

• Power cable

• Lithium battery CR2025

• Warranty card

In the box that the speakers came in you should find the following accessories:

• Subwoofer connecting cable

• Speaker stands (x2)

• Non skid pads (for satellite speakers (x8), for subwoofer (x4))

Using this manual

This manual is for the XC–L77 Stereo CD Receiver, CT–L77 Stereo Cassette Deck and

S–L8/S–L9/S–L9-A speaker system. It is split into two broad sections; the first covers

setting up, and the second, using the system. Set up, which starts here, shows you how

to install and connect up the system.

In the second section of the manual, starting on page 13, you'll learn how to use every

feature of the CD receiver/cassette deck system. The final part of the manual provides a

troubleshooting section and technical specifications.

Putting the battery in the remote

1 Turn over the remote control. Push a ball-point pen into the hole to release

the battery cover and slide it off.

2 Put in the supplied battery, taking care to match the plus and minus sides

with the markings inside the compartment.

3 Slide the cover back on, and your remote is ready for use.

CAUTION:

• Remove the battery if the remote is not going to be used for a month or more.

• Remove dead batteries promptly— they can leak and damage the unit.

• If the remote is connected to the display, no battery is necessary for it to work.

The battery is not recharged by connecting the remote to the display, however.

Using the remote control

Keep in mind the following when using the remote control unit:

• Make sure that there are no obstacles in between the remote and the remote

sensor on the unit.

• Use within the operating range and angle, as shown in the diagram left.

• Remote operation may become unreliable if strong sunlight or fluorescent

light is shining on the unit's remote sensor.

• Remote controllers for different devices can interfere with each other. Avoid

using remotes for other equipment located nearby this unit.

• Replace the battery when you notice the operating range of the remote fall.

• On the rear of the remote there is a gold-coloured connector that links the

remote with the display unit. Avoid touching this when using the remote

separately.

1 Before You Start

• FM wire antenna

• Display unit connecting cable

(for remote control)

• This instruction manual

• Speaker cables (x2)

• Screws (x4)

(to attach speaker stands)