Pioneer XC-L77 Instruções de funcionamento - Página 5
Procurar online ou descarregar pdf Instruções de funcionamento para Recetor para automóvel Pioneer XC-L77. Pioneer XC-L77 48 páginas. Stereo cd receiver; speaker system; stereo cassette deck
Imprimir página
1
2
3
CAUTION
Danger of explosion if battery is incor-
rectly replaced.
Replace only with the same or
equivalent type recommended by the
manufacturer. Discard used batteries
according to the manufacturer's
instructions.
7 meters
o
30
30
Operating range of the remote
control unit
Checking What's in the Box
Thank you for buying this Pioneer product. Before starting to set up your new stereo
system, please check that you received the following supplied accessories in the
XC–L77 Stereo CD Receiver box:
• AM loop antenna
• Power cable
• Lithium battery CR2025
• Warranty card
In the box that the speakers came in you should find the following accessories:
• Subwoofer connecting cable
• Speaker stands (x2)
• Non skid pads (for satellite speakers (x8), for subwoofer (x4))
Using this manual
This manual is for the XC–L77 Stereo CD Receiver, CT–L77 Stereo Cassette Deck and
S–L8/S–L9/S–L9-A speaker system. It is split into two broad sections; the first covers
setting up, and the second, using the system. Set up, which starts here, shows you how
to install and connect up the system.
In the second section of the manual, starting on page 13, you'll learn how to use every
feature of the CD receiver/cassette deck system. The final part of the manual provides a
troubleshooting section and technical specifications.
Putting the battery in the remote
1 Turn over the remote control. Push a ball-point pen into the hole to release
the battery cover and slide it off.
2 Put in the supplied battery, taking care to match the plus and minus sides
with the markings inside the compartment.
3 Slide the cover back on, and your remote is ready for use.
CAUTION:
• Remove the battery if the remote is not going to be used for a month or more.
• Remove dead batteries promptly— they can leak and damage the unit.
• If the remote is connected to the display, no battery is necessary for it to work.
The battery is not recharged by connecting the remote to the display, however.
Using the remote control
Keep in mind the following when using the remote control unit:
• Make sure that there are no obstacles in between the remote and the remote
sensor on the unit.
• Use within the operating range and angle, as shown in the diagram left.
• Remote operation may become unreliable if strong sunlight or fluorescent
o
light is shining on the unit's remote sensor.
• Remote controllers for different devices can interfere with each other. Avoid
using remotes for other equipment located nearby this unit.
• Replace the battery when you notice the operating range of the remote fall.
• On the rear of the remote there is a gold-coloured connector that links the
remote with the display unit. Avoid touching this when using the remote
separately.
1 Before You Start
• FM wire antenna
• Display unit connecting cable
(for remote control)
• This instruction manual
• Speaker cables (x2)
• Screws (x4)
(to attach speaker stands)
5