Pioneer DCS-370 Betriebsanleitung - Seite 41

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Empfänger Pioneer DCS-370 herunter. Pioneer DCS-370 48 Seiten. Pioneer dvd receiver operating instructions

Seite drucken

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is

something wrong with this component, check the points below. Sometimes the trouble may lie in

another component. Investigate the other components and electrical appliances being used. If the

trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer

authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity

disconnect the plug from the outlet and insert again to return to normal operating conditions.

General

Problem

The power does not turn

on, or switches off

suddenly (an error

message may be

displayed at startup).

No sound is output

when a function is

selected.

No sound from surround

or center speakers.

Can't operate the remote

control.

TRAYLOCK shows in the

display and the tray can't

be ejected.

SND. DEMO shows in

the display and the unit

can't be controlled.

Remedy

• Wait for one minute before switching back on.

• Make sure there are no loose strands of wire touching the unit. This could cause

the system to shut off automatically.

• Check that the speakers are connected correctly.

• Make sure the voltage of the mains power source is correct for the model.

• Try reducing the volume level.

• If the problem persists, take it to your nearest Pioneer authorized service center

or your dealer for servicing.

• If you're using the line input, make sure the component is connected correctly

(see Connecting auxiliary audio components on page 32).

• Press MUTE on the remote control to turn muting off.

• Turn up the volume.

• Refer to Setting the channel levels on page 10 to check the speaker levels.

• When TUNER or LINE is selected, you can only hear the source in stereo. Switch

the input source to DVD/CD or USB for multichannel sound.

• Check that the Line Out mode hasn't been switched on (see Line Out options on

page 33).

• Check that you haven't selected the STEREO mode (see Listening in surround

sound on page 14).

• Connect the speakers properly (refer to the Setup Guide).

• Replace the batteries (refer to the Setup Guide).

• Operate within 7 m, 30° of the remote sensor (refer to the Setup Guide).

• Remove any obstacles or operate from another position.

• Avoid exposing the remote sensor on the front panel to direct light.

• To operate other Pioneer components, make sure that the control cable and

analog audio cable are connected.

• Press and hold  (OPEN/CLOSE) on the front panel for about eight seconds.

Then the tray can be opened/closed using  (OPEN/CLOSE).

• Press and hold  (stop) on the front panel for about five seconds. The disc tray

ejects automatically to indicate the Sound Demo mode is disabled.