Pioneer VSX-9500S VSX-7500S Betriebsanleitung - Seite 19
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Stereo-Empfänger Pioneer VSX-9500S VSX-7500S herunter. Pioneer VSX-9500S VSX-7500S 48 Seiten.
Auch für Pioneer VSX-9500S VSX-7500S: Betriebsanleitung (48 seiten)
Seite drucken
TUNER
AUTO OR MANUAL TUNING
1. Press the POWER
switch to the ON position.
NOTE:
8e sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FM broadcasts.
2. Use the BAND selector to choose either FM or AM.
AUTO tuning:
Auto tuning is convenient when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
normally listen to
For AUTO tuning:
3. Set the AUTO/MANUAL
switch to the auto tuning mode.
« In the Auto Tuning mode, the | AUTO | indicator will light.
4. Press the ''+"' or ''~"' switch of the TUNING switches.
° Pressing '' +' causes scanning to take place in the direction of
increasing frequency. Pressing ''— '' causes scanning to take piace
in the direction of decreasing frequency.
* When a station is received, scanning will stop (the | TUNED
indicator lights). If you wish to receive a different station, press
the TUNING switch (''+" or "'~"') again.
5
HITS
switch
4
MANUAL
tuning:
This is the ''normal"' tuning mode. Each time the TUNING switch "+ °"
or' —"' is pressed, the tuning frequency changes by one channel step,
allowing you to find stations manually.
For MANUAL tuning:
3. Set the AUTO/MANUAL
switch to the manual tuning mode.
¢ When in the Manual Tuning mode, the | AUTO
jindicator will go
out.
4. Press the '+' or "'—"' switch of the TUNING switch as necessary
to set to the frequency of the desired station.
* Each time the switch is pressed, the tuning frequency will change
by one step in the direction corresponding to the switch pressed.
When
pressed continuously, the reception frequency will also
change continuously.
* When a station is received, the [TUNED J indicator will light.
* When the received station is broadcasting a program in FM stereo,
the | STEREO
|indicator will light. The STEREO indicator will not
light if the FM MODE switch is set to FM MONO.
5. Adjust the MASTER VOLUME
and tone as desired.
NOTE:
© When Auto Tuning is used, correct reception may not be possible
for very distant stations or stations with very weak signals. In this
event, Manual Tuning is recommended,
¢ The}
TUNED
jindicator may not light with broadcasts received over
long distances, or when the broadcast signals are extremely weak.
HITS function
When the HITS switch is pressed, the receiver searches from the current
frequency for the nearest station and tunes in the first one it finds. If
no receivable siation is found within the band range, the receiver returns
to the state it was in before the switch was pressed.
19
<ARB1173>