Pioneer A-J7 Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer A-J7 herunter. Pioneer A-J7 7 Seiten.

Seite drucken

OPERATIONS

BEFORE BEGINNING OPERATIONS

1. Turn VOLUME knob fully to the left, to the MIN position.

2. Switch POWER on.

not turn on unless the CD-tuner's power is on.

3. Turn BALANCE knob to the center position.

4. Select your desired position with DIRECT switch.

¢ When it is on, you cannot switch sound character, make balance

adjustments, or use a component connected to the adaptor jack.

PLAYBACK PROCEDURES

5. Select the source with the input selector switch.

CD+- TUNER.

* To listen to a tape on cassette deck, select TAPE.

¢ If you want to listen to a record, select PHONO.

* Select LINE to enjoy playback from other audio components.

OPERATION (Play)

The Auto Function

When used in combination with the FD-J7 CD tuner and the T-J7

cassette deck, this unit's INPUT SELECTOR switches automatically

when the CDeTuner or deck are operated.

¢ If you press the CD tuner CD play key or the tuner. band key, it

switches to

CD» TUNER.

6. Selecting SOUND CHARACTER

(Tone mode)

You can select any one of the eight available modes, MILD 1 to 3,

FLAT, HARD 1 to 4, to get just the sound you want. Sound character

divides the full range of frequencies into three frequency bands.

Changing the levels of these bands creates a variety of tonal effects.

MILD3

This

boosts

mid-range

frequencies

while

cutting low-range

frequencies.

Ideal when

listening to news programs.

MILD2

This boosts mid-range frequencies, making it

ideal for vocal sources.

MILD1

This has the same characteristics as MILD2

and MILD3, but by shifting the phase, it acts

as a wide mode to give you a sound with a

more spacious feel.

FLAT

This is the flat position which gives you sound

unaltered by equalization adjustments.

HARD1

By boosting low-range frequencies, this gives

you a rich bass sound even in rooms that tend

to absorb low frequency sounds. Like MILD1,

it acts as a wide mode.

HARD2

This strongly boosts low-range frequencies to

give you a powerful bass sound. Particularly

useful when you are using small speakers.

HARD3

This boosts both low-range and high-range

frequencies to give you a good sound even

when listening at low volume levels. Equivalent

to Loudness.

HARD4

The same

as HARD3,

but providing much

stronger boost characteristics. Equivalent to

Loudness.

7. Starting Play

Operate the desired component to start play.

8. Adjust volume level with VOLUME control.

NOTE:

/f MUTING is on, there will be no sound.

Make sure MUTING indicator is off.

RECORDING TO AUDIO TAPE

'Record to the cassette deck connected to the TAPE jacks.

(For cassette deck operation, refer to the deck's operation manual.)

1. Select the source to record from with the Input Selector switch.

(Select a source other than TAPE).

' 2. Operate the cassette deck to begin recording.

NOTE:

Recording via an adaptor connected to ADAPTOR jack is not possible.