Pioneer GM-A5602 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Pioneer GM-A5602 herunter. Pioneer GM-A5602 18 Seiten. Bridgeable two-channel power amplifier
Auch für Pioneer GM-A5602: Benutzerhandbuch (45 seiten), Benutzerhandbuch (11 seiten), Benutzerhandbuch (49 seiten)

Seite drucken

Connecting the units

Connection diagram

1 Special red battery wire

RD-223 (sold separately)

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive

inal.

2 Ground wire (Black)

RD-223 (sold separately)

Connect to metal body or chassis.

3 Car stereo with RCA output jacks (sold sepa-

rately)

4 External output

5 Connecting wire with RCA pin plugs (sold se-

parately)

6 Speaker input terminal (use a connector in-

cluded)

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire on page 9.

7 RCA input jack

8 System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo.

The female terminal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal via the ignition switch.

9 Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire on page 9.

a Fuse 30 A × 2 (GM-A5602) / 25 A × 1 (GM-

A3602)

b Fuse (30 A) × 2

c Grommet

d Rear side

e Front side

Before connecting the

amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

battery term-

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never wire the speaker negative cable directly

to ground.

! Never band together multiple speaker s nega-

tive cables.

! If the system remote control wire of the ampli-

fier is connected to the power terminal via the

ignition switch (12 V DC), the amplifier will re-

main on with the ignition whether the car

stereo is on or off, which may exhaust battery

if the engine is at rest or idling.

Section