Pioneer GM-A5602 Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Pioneer GM-A5602 herunter. Pioneer GM-A5602 18 Seiten. Bridgeable two-channel power amplifier
Auch für Pioneer GM-A5602: Benutzerhandbuch (45 seiten), Benutzerhandbuch (11 seiten), Benutzerhandbuch (49 seiten)
Seite drucken
Section
Connecting the units
03
! Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
About bridged mode
! Do not install or use this amplifier by wiring
speakers rated at 4 W (or lower) in parallel to
achieve a 2 W (or lower) bridged mode (Dia-
gram B).
Amplifier damage, smoke, and overheating
could result from improper bridging. The am-
plifier surface could also become hot to the
touch and minor burns could result.
To properly install or use a bridged mode and
achieve a 4 W load, wire two 8 W speakers in
parallel with Left
or use a single 4 W speaker.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
! For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
8
En
and Right
(Diagram A)
to 8 W for stereo connection, or 4 W to 8 W for
monaural and other bridge connection.
Subwoofer
Speaker channel
Power
Nominal input:
Two-channel output
Min. 150 W (GM-A5602)
Min. 60 W (GM-A3602)
Nominal input:
One-channel output
Min. 450 W (GM-A5602)
Min. 180 W (GM-A3602)
Other than subwoofer
Speaker channel
Power
MAX input:
Two-channel output
Min. 300 W (GM-A5602)
Min. 120 W (GM-A3602)
MAX input:
One-channel output
Min. 900 W (GM-A5602)
Min. 400 W (GM-A3602)
Connecting the speakers
The speaker output mode can be two-channel
(stereo) or one-channel (mono). Connect the
speaker leads to suit the mode according to
the figures shown below.
Two-channel output (Stereo)
1 Speaker (Left)
2 Speaker (Right)
1
2