Pioneer SA-9800 Betriebsanleitung

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Verstärken Pioneer SA-9800 herunter. Pioneer SA-9800 17 Seiten.

Seite drucken

STEREO

AMPLIFIER

@Q PIONEER'

A=-93800

OPERATING

INSTRUCTIONS

These

operating

instructions are based on the model

HG,

and they can be used for the S, 8/G models. The differences

between the models are given below.

Power requirements

SA-9800/HG

SA-9800/S, 8

220V/240V

(switchable), 50Hz, 60Hz

110V/120V/220V/240V

(switchable),

50Hz, 60Hz

NOTE:

Read

through

the section on the LINE

VOLTAGE

LECTOR SWITCH on page 5 before using your amplifier

and check

that the voltage selector switch is set correctly

for use in your area.

Power cords

SA-9800/HG;

This is configured as an AC inlet type.

Use a separate power cord in order to

connect the power supply.

SA-9800/S, S/G:

The

power

cord

is mounted

at the

rear.

Cabinet

SA-9800/HG, S:

SA-9800/S/G;

Others

SA-9800/HG:

Black cabinet

Walnut grained finished cabinet.

The DIN-type recording/playback

socket

is provided

the rear panel

The

outlets

are

provided

the

rear panel.

SA-9800/S, S/

Pe MPORTANT

To prevent electric shock, do not remove cover. No user

serviceable parts inside, refer servicing to qualified serv-

ice personnel.

Always

disconnect

all the equipment

from

the mains

supply

when

disconnecting

the signal leads, The power

cord should be connected last, make sure that the power

switch is off. First, insert the female appliance connector

of the mains cord

into

the AC INLET,

then plug the

cord to the wall socket, Be sure that the appliance con

nector is fully inserted into the AC INLET.

Unplug the set from the wall socket when it is not to be

used for an extended period of time,

WARNING

THIS APPARATUS MUST BE EARTHED.

FOR YOUR SAFETY

1, Insert this piug only into effectively earthed three-pin

plug-socket outlet.

2. If any doubt

exists regarding the earthing, consult a

qualified electrician,

[ 3, Extension cords, if used, must be three-core correctly

wired.

—

FOR USE IN UNITED KINGDOM AND

AUSTRALIA

CAUTION 240V:

Mains supply voltage is facto-

ry adjusted at 240V.

FOR USE IN UNITED KINGDOM

The wires in this mains lead are coloured in accordance

with the following code:

Green-and-Yellow:

Earth

Blue:

Neutral

Brown:

Live

As the colours of the wires in the mains lead of this ap-

paratus may

not correspond with the coloured marking

identifying

the

terminals

in your plug proceed

as fol-

lows,

The

wire

which

is coloured

green-and-yellow

must

connected to the terminal which

is marked with the let-

ter E or with the safety earth symbol 2 or coloured

green or green-and-yellow,

The wire which is coloured blue must be connected to

the terminal which is marked with the letter N or colour-

ed black,

The wire which is coloured brown must be connected to

the terminal which is marked with the letter L or colour

ed red,