Pioneer SA-9800 Руководство по эксплуатации
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Усилитель Pioneer SA-9800. Pioneer SA-9800 17 страниц.
STEREO
AMPLIFIER
@Q PIONEER'
Ss
A=-93800
"a
HG
OPERATING
INSTRUCTIONS
These
operating
instructions are based on the model
HG,
and they can be used for the S, 8/G models. The differences
between the models are given below.
Power requirements
SA-9800/HG
SA-9800/S, 8
220V/240V
(switchable), 50Hz, 60Hz
110V/120V/220V/240V
(switchable),
50Hz, 60Hz
NOTE:
Read
through
the section on the LINE
VOLTAGE
SE
LECTOR SWITCH on page 5 before using your amplifier
and check
that the voltage selector switch is set correctly
for use in your area.
Power cords
SA-9800/HG;
This is configured as an AC inlet type.
Use a separate power cord in order to
connect the power supply.
SA-9800/S, S/G:
The
power
cord
is mounted
at the
rear.
Cabinet
SA-9800/HG, S:
SA-9800/S/G;
Others
SA-9800/HG:
Black cabinet
Walnut grained finished cabinet.
The DIN-type recording/playback
socket
is provided
on
the rear panel
The
AC
outlets
are
provided
on
the
rear panel.
SA-9800/S, S/
Pe MPORTANT
To prevent electric shock, do not remove cover. No user
serviceable parts inside, refer servicing to qualified serv-
ice personnel.
Always
disconnect
all the equipment
from
the mains
supply
when
disconnecting
the signal leads, The power
cord should be connected last, make sure that the power
switch is off. First, insert the female appliance connector
of the mains cord
into
the AC INLET,
then plug the
cord to the wall socket, Be sure that the appliance con
nector is fully inserted into the AC INLET.
Unplug the set from the wall socket when it is not to be
used for an extended period of time,
WARNING
THIS APPARATUS MUST BE EARTHED.
FOR YOUR SAFETY
1, Insert this piug only into effectively earthed three-pin
plug-socket outlet.
2. If any doubt
exists regarding the earthing, consult a
qualified electrician,
[ 3, Extension cords, if used, must be three-core correctly
wired.
—
FOR USE IN UNITED KINGDOM AND
AUSTRALIA
CAUTION 240V:
Mains supply voltage is facto-
ry adjusted at 240V.
FOR USE IN UNITED KINGDOM
The wires in this mains lead are coloured in accordance
with the following code:
Green-and-Yellow:
Earth
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this ap-
paratus may
not correspond with the coloured marking
identifying
the
terminals
in your plug proceed
as fol-
lows,
The
wire
which
is coloured
green-and-yellow
must
be
connected to the terminal which
is marked with the let-
ter E or with the safety earth symbol 2 or coloured
green or green-and-yellow,
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or colour-
ed black,
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or colour
J
ed red,