Aeotec ZW187 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör Aeotec ZW187 herunter. Aeotec ZW187 9 Seiten. Recessed door sensor gen7
Auch für Aeotec ZW187: Handbuch (11 seiten)

Seite drucken

3. Press the Z-Wave Button on your Recessed Door Sensor 7 and quickly release the button (should only be a

quick tap action on the button).

Recessed Door Sensor 7 will quickly ﬂash its red LED up to 30 seconds or until it is paired successfully. If

successfully paired, the red LED will become solid for 10 seconds.

If your Recessed Door Sensor failed to pair, the LED will return to slow breathing LED. If it is this case, please

return to step 2.

4. If you pairing with S2 encryption/security, enter the ﬁrst 5 digits of the DSK into your controller/gateway/hub

interface when requested.

When Recessed Door Sensor 7 successfully joins your Z-Wave network its LED will turn solid red for 10 seconds. If

LED

becomes slow fade-in fade-out Red color before turning oﬀ, it means the device is still unable to join your Z-Wave

network; repeat the above steps and please contact us for further support if needed.

Install your Recessed Door Sensor.

With Main Sensor powered and activated, it is now time to inlay it within your selected door frame. Before beginning, it

is important to select a suitable position for your Recessed Door Sensor. For optimal performance, your sensor should

be:

1. Either installed at the top of a door or the side of a door.

2. Positioned away from metal that could interfere with its magnetic functionality or wireless functions. This

includes your door's plate, handle or lock mechanism.

3. Installed in a suitable location to ensure a clear (between 1mm and 5mm) separation when the door is closed.

4. Positioned exactly above or beside the position in which Magnetic Sensor will be inlaid.

The rectangular areas highlighted above are optimal installation positions.

Step 1 - Drill for Sensors main body.

Prepare the space for Main Sensor by drilling a hole into your doorframe using a 20mm/0,75 inch wide drill bit (you

can use a slightly larger drill bit if needed). The hole should be 65mm/2,56 inch deep.

Although 19mm/0,75 inch is stated for the drill bit size, it is advised that the drill bit should be larger to allow you to

easily remove Recessed Door Sensor Gen7 later.