Aeotec Smart Switch 6 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Aeotec Smart Switch 6 herunter. Aeotec Smart Switch 6 12 Seiten.
Auch für Aeotec Smart Switch 6: Handbuch (7 seiten)

Seite drucken

Yellow

Red

While the Switch is in an OFF state:



The LED will appear as a light purple.

You can also configure the brightness and color of RGB LED when the Smart Switch is

in Night Light mode by setting Parameter 81 [1 byte] = 2, or set it into Momentary mode

by setting Parameter 81 [1 byte] = 1 to have the LED turn off after 5 seconds during a

state change.

Removing your Smart Switch from a Z-Wave network.

Your Smart Switch can be removed from your Z-Wave network at any time. You'll need

to use your Z-Wave network's main controller to do this and the following instructions

will tell you how to do this using a Aeotec by Aeon Labs' Z-Stick or Minimote controller.

If you are using other products as your main Z-Wave controller, please refer to the part

of their respective manuals that tells you how to remove devices from your network.

If you're using an existing gateway:

1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to

your controller/gateway manual on how to do this)

2. Press the Action Button on your Switch.

3. If your switch has been successfully unlinked from your network, its LED will become a

rainbow gradient. If linking was unsuccessful, the LED will become green or purple

depending on how your LED mode is set.

[1500W,

2500W]

[2500W,

3000W]