Aeotec Smart Switch 6 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik Aeotec Smart Switch 6. Aeotec Smart Switch 6 12 stron.
Również dla Aeotec Smart Switch 6: Podręcznik (7 strony)
Drukuj stronęYellow
Red
While the Switch is in an OFF state:
The LED will appear as a light purple.
You can also configure the brightness and color of RGB LED when the Smart Switch is
in Night Light mode by setting Parameter 81 [1 byte] = 2, or set it into Momentary mode
by setting Parameter 81 [1 byte] = 1 to have the LED turn off after 5 seconds during a
state change.
Removing your Smart Switch from a Z-Wave network.
Your Smart Switch can be removed from your Z-Wave network at any time. You'll need
to use your Z-Wave network's main controller to do this and the following instructions
will tell you how to do this using a Aeotec by Aeon Labs' Z-Stick or Minimote controller.
If you are using other products as your main Z-Wave controller, please refer to the part
of their respective manuals that tells you how to remove devices from your network.
If you're using an existing gateway:
1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to
your controller/gateway manual on how to do this)
2. Press the Action Button on your Switch.
3. If your switch has been successfully unlinked from your network, its LED will become a
rainbow gradient. If linking was unsuccessful, the LED will become green or purple
depending on how your LED mode is set.
[1500W,
2500W]
[2500W,
3000W]