Aeotec Z-Stick Gen5 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Adapter Aeotec Z-Stick Gen5 herunter. Aeotec Z-Stick Gen5 5 Seiten. Z-wave usb adapter
Auch für Aeotec Z-Stick Gen5: Handbuch (2 seiten), Handbuch (11 seiten)

Seite drucken

In order to use the Z-Stick Gen5 and control your Z-Wave network, you must download a third party software to have

full control over your software. You can find all known third party softwares in this link:

https://aeotec.freshdesk.com/solution/articles/6000042049-host-software

(https://aeotec.freshdesk.com/solution/articles/6000042049-host-software)

We do not provide software apart from:

Backup Tool

Advanced use.

Backup Tool for Z-Stick Gen5

You are able to backup the Z-Stick Gen5 using our Z-Stick Gen5 Backup Software in any case you need to restore an

older save of your network, or replace a failed Z-Stick Gen5. This way you will never have to re-do your network if there

are catastrophic issues.

You can download the installation setup for Backup Software here:

https://aeotec.freshdesk.com/solution/articles/6000108806-z-stick-gen5-backup-software

(https://aeotec.freshdesk.com/solution/articles/6000108806-z-stick-gen5-backup-software)

You can learn how to use Backup Software here to backup, and

restore: https://aeotec.freshdesk.com/solution/articles/6000167023-how-to-use-z-stick-gen5-backup-software-

backup-and-restore-

(https://aeotec.freshdesk.com/solution/articles/6000167023-how-to-use-z-stick-gen5-backup-

software-backup-and-restore-)

Installation and Maintenance Application (IMA) feature.

When Z-Stick is in Serial API- Mode and acts a primary controller, it can measure the network health for each device in the

network. The different colour of LED indicates the communication quality between the Z-Stick Controller and devices in the

network.

When Z-Stick acts an independent / secondary controller that has been un-plugged from the USB host, it also can

measure the network health in Z-Wave network. The different colour of LED on Z-Stick indicates the communication

quality between the Central Controller and the current location of Z-Stick in the network.

Short press the Action Button 5 times.

If the colour of the LED light changes to purple and is then followed by fast blinking that means it goes into the IMA

feature. The colour of the LED indicator will be changed according to the network health level. A green LED light

means that the current communication quality is more than 95% on -7dBm. An orange LED light means that the current

communication quality is more than 95% on 0dBm. A purple LED light means that the current communication quality is

less than 95% on 0dBm. A red LED light means that the current communication has failed.

Short press the Action Button 5 times again, Z-Stick will automatically exit the IMA feature.

SerialAPI-Mode: Allowing a Host Processor To Take Control of the Z-Stick and

Take Part in the Z-Wave Network.

Note:

To initiate SerialAPI-Mode, plug Z-Stick into the USB connector of the host (i.e. PC, MAC, or Gateway).