Aeotec Z-Stick Gen5 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Адаптер Aeotec Z-Stick Gen5. Aeotec Z-Stick Gen5 5 сторінок. Z-wave usb adapter
Також для Aeotec Z-Stick Gen5: Посібник (2 сторінок), Посібник (11 сторінок)
Друкувати сторінку
In order to use the Z-Stick Gen5 and control your Z-Wave network, you must download a third party software to have
full control over your software. You can find all known third party softwares in this link:
https://aeotec.freshdesk.com/solution/articles/6000042049-host-software
(https://aeotec.freshdesk.com/solution/articles/6000042049-host-software)
We do not provide software apart from:
Backup Tool
Advanced use.
Backup Tool for Z-Stick Gen5
You are able to backup the Z-Stick Gen5 using our Z-Stick Gen5 Backup Software in any case you need to restore an
older save of your network, or replace a failed Z-Stick Gen5. This way you will never have to re-do your network if there
are catastrophic issues.
You can download the installation setup for Backup Software here:
https://aeotec.freshdesk.com/solution/articles/6000108806-z-stick-gen5-backup-software
(https://aeotec.freshdesk.com/solution/articles/6000108806-z-stick-gen5-backup-software)
You can learn how to use Backup Software here to backup, and
restore: https://aeotec.freshdesk.com/solution/articles/6000167023-how-to-use-z-stick-gen5-backup-software-
backup-and-restore-
(https://aeotec.freshdesk.com/solution/articles/6000167023-how-to-use-z-stick-gen5-backup-
software-backup-and-restore-)
Installation and Maintenance Application (IMA) feature.
When Z-Stick is in Serial API- Mode and acts a primary controller, it can measure the network health for each device in the
network. The different colour of LED indicates the communication quality between the Z-Stick Controller and devices in the
network.
When Z-Stick acts an independent / secondary controller that has been un-plugged from the USB host, it also can
measure the network health in Z-Wave network. The different colour of LED on Z-Stick indicates the communication
quality between the Central Controller and the current location of Z-Stick in the network.
Short press the Action Button 5 times.
If the colour of the LED light changes to purple and is then followed by fast blinking that means it goes into the IMA
feature. The colour of the LED indicator will be changed according to the network health level. A green LED light
means that the current communication quality is more than 95% on -7dBm. An orange LED light means that the current
communication quality is more than 95% on 0dBm. A purple LED light means that the current communication quality is
less than 95% on 0dBm. A red LED light means that the current communication has failed.
Short press the Action Button 5 times again, Z-Stick will automatically exit the IMA feature.
SerialAPI-Mode: Allowing a Host Processor To Take Control of the Z-Stick and
Take Part in the Z-Wave Network.
Note:
To initiate SerialAPI-Mode, plug Z-Stick into the USB connector of the host (i.e. PC, MAC, or Gateway).