Aeotec Z-Stick Gen5 Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Адаптер Aeotec Z-Stick Gen5. Aeotec Z-Stick Gen5 5 сторінок. Z-wave usb adapter
Також для Aeotec Z-Stick Gen5: Посібник (2 сторінок), Посібник (11 сторінок)
Друкувати сторінку
Z-Stick Gen5 is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet locations.
Quick start.
Z-Stick operates in three distinct modes: Inclusion-Mode, Removal- Mode and SerialAPI-Mode. Both Inclusion-Mode
and Removal-Mode require Z-Stick to be unplugged from the USB connector of the host, while SerialAPI-Mode
requires that Z-Stick to be plugged into the USB connector of the host. Software drivers for the "ZW050x_USB_VCP_
PC_Driver" may need to be installed in order for Z-Stick to be recognized on some computers.
To quickly get started, please follow our Z-Stick Gen5 Quick Start - Just the essentials article.
(https://aeotec.freshdesk.com/solution/articles/6000092802-z-stick-gen5-quick-start-just-the-essentials)
Recommended software to start with.
We recommend free software Domoticz if you are just getting started, you can view this guide here: Z-Stick Gen5
and how to get started with Domoticz.
stick-gen5-with-domoticz)
Inclusion-Mode: Adding/Including Z-Wave Devices into the Z-Wave Network.
1. To initiate Inclusion-Mode, unplug Z-Stick from the USB connector and then tap the Action Button. (The blue LED
will blink slowly.)
2. To include a new Z-Wave device into the network, simply go to the device with Z-Stick and press the button on the
device you wish to include. (The blue LED on Z-Stick will blink fast during a network neighbour discovery and stay solid
for 2 seconds to indicate successful inclusion of the device into the network.)
3. The blue LED will then return to blinking slowly, indicating readiness for further device inclusions. Repeat step 2 for
each device you wish to include.
4. Tap Z-Stick's Action Button to turn it off or it will automatically exit the removal mode after 30 seconds of inactivity.
Removal-Mode: Deleting/ Removing/Excluding Z-Wave Devices from the Z-Wave
Network.
1. To initiate Removal-Mode, unplug Z-Stick from the USB connector. Then press and hold down the Action Button for
approximately 2 seconds. (The orange LED will blink fast.)
2. To remove a Z-Wave device from the network, simply go to the device with Z-Stick and press the button on the
device you wish to remove. (The blue LED on Z-Stick will immediately stay solid for 2 seconds to indicate successful
removal from the network.)
3. The orange LED will then return to blink fast, indicating readiness for further device exclusions. Repeat step 2 for
each device you wish to exclude.
4. Tap Z-Stick's Action Button to turn it off or it will automatically exit the removal mode after 30 seconds of inactivity.
Third party Host Software.
(https://aeotec.freshdesk.com/solution/articles/6000199837-quick-start-z-