Aeotec Z-Stick Gen5 사용자 설명서 - 페이지 2

{카테고리_이름} Aeotec Z-Stick Gen5에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Z-Stick Gen5 5 페이지. Z-wave usb adapter
Aeotec Z-Stick Gen5에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지), 매뉴얼 (11 페이지)

페이지 인쇄

Z-Stick Gen5 is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet locations.

Quick start.

Z-Stick operates in three distinct modes: Inclusion-Mode, Removal- Mode and SerialAPI-Mode. Both Inclusion-Mode

and Removal-Mode require Z-Stick to be unplugged from the USB connector of the host, while SerialAPI-Mode

requires that Z-Stick to be plugged into the USB connector of the host. Software drivers for the "ZW050x_USB_VCP_

PC_Driver" may need to be installed in order for Z-Stick to be recognized on some computers.

To quickly get started, please follow our Z-Stick Gen5 Quick Start - Just the essentials article.

(https://aeotec.freshdesk.com/solution/articles/6000092802-z-stick-gen5-quick-start-just-the-essentials)

Recommended software to start with.

We recommend free software Domoticz if you are just getting started, you can view this guide here: Z-Stick Gen5

and how to get started with Domoticz.

stick-gen5-with-domoticz)

Inclusion-Mode: Adding/Including Z-Wave Devices into the Z-Wave Network.

1. To initiate Inclusion-Mode, unplug Z-Stick from the USB connector and then tap the Action Button. (The blue LED

will blink slowly.)

2. To include a new Z-Wave device into the network, simply go to the device with Z-Stick and press the button on the

device you wish to include. (The blue LED on Z-Stick will blink fast during a network neighbour discovery and stay solid

for 2 seconds to indicate successful inclusion of the device into the network.)

3. The blue LED will then return to blinking slowly, indicating readiness for further device inclusions. Repeat step 2 for

each device you wish to include.

4. Tap Z-Stick's Action Button to turn it off or it will automatically exit the removal mode after 30 seconds of inactivity.

Removal-Mode: Deleting/ Removing/Excluding Z-Wave Devices from the Z-Wave

Network.

1. To initiate Removal-Mode, unplug Z-Stick from the USB connector. Then press and hold down the Action Button for

approximately 2 seconds. (The orange LED will blink fast.)

2. To remove a Z-Wave device from the network, simply go to the device with Z-Stick and press the button on the

device you wish to remove. (The blue LED on Z-Stick will immediately stay solid for 2 seconds to indicate successful

removal from the network.)

3. The orange LED will then return to blink fast, indicating readiness for further device exclusions. Repeat step 2 for

each device you wish to exclude.

4. Tap Z-Stick's Action Button to turn it off or it will automatically exit the removal mode after 30 seconds of inactivity.

Third party Host Software.

(https://aeotec.freshdesk.com/solution/articles/6000199837-quick-start-z-