Ariston TCF 87B Gebrauchsanweisung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Ariston TCF 87B herunter. Ariston TCF 87B 17 Seiten.

Seite drucken

19510300500_AUS

English, All Logos to be Ariston

Troubleshooting

One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the

following troubleshooting suggestions.

Problem:

The dryer won't start

Drying cycle will not begin.

It is taking a long time to dry

The water full icon

flashing and

displayed

but the dryer has only been

running for a short period.

Empty water icon

is on and

the water container is not full.

The Display shows a fault

code F followed by one or two

numbers

Programme finishes and

clothes damper than expected

{PDF Created 18/01/13 22:28:00}

Possible causes / Solutions:

• The plug is not plugged into the socket, or not making contact.

• There has been a power failure.

• The fuse has blown. Try to plug another appliance into the socket.

• You are using an extension cord. Try to plug the dryer's power cord

directly into the socket.

• The door is not closed securely.

• The PROGRAMMES knob has not been set properly (see Start and

Programmes).

• The START button has not been pressed (see Start and Programmes).

• You have set a delay time (see Start and Programmes).

• The filter has not been cleaned (see Maintenance).

•

The water container needs emptying... The 'water Container full icon'

flashing, The display shows

Maintenance).

• The condenser needs cleaning (see Maintenance).

• The temperature setting is not ideal for the type of fabric you are

• drying (see Start and Programmes, and Laundry ).

• The correct drying time has not been selected for this load

(see Laundry).

• The air intake grille is obstructed (see Installation and see Maintenance).

• The items are too wet (see Laundry).

The dryer is overloaded (see Laundry).

• The water container was probably not emptied at the start of the programme.

Do not wait for the empty water signal always check and empty the container

before starting a new drying programme. (see Maintenance).

•

This is normal if the light is on its just a reminder to empty the container. (see

Start and Programmes)

• If the display shows a fault, Turn off and remove plug, Clean the Filter and

Condensing Unit (see Maintenance). Then replace plug turn on and start

another program. If a fault is then displayed. Note down the number and

contact the service centre (see Service)

! For safety the dryer has a maximum programme time of 4 hours. If an

automatic programme has not sensed the required final moisture in this time the

dryer will complete the programme and stop. Check the above points and run the

programme again, if the results are still to damp, contact the service centre (see

Service).

and the empty water icon

is on.

TD4265FUA Issue 2

(see