Whirlpool WUR35X24HZ Handbuch für Gebrauch und Pflege - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Kühlschrank Whirlpool WUR35X24HZ herunter. Whirlpool WUR35X24HZ 36 Seiten. Under counter refrigerator
Auch für Whirlpool WUR35X24HZ: Handbuch für Gebrauch und Pflege (36 seiten)
Seite drucken
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your beverage center, allow for a
¼" (6.35 mm) space on each side and at the top. When installing
your beverage center next to a fixed wall, leave 2½" (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
NOTE: It is recommended that you do not install the beverage
center near an oven, radiator, or other heat source. Do not install
in a location where the temperature will fall below 55°F (13°C).
For best performance, do not install the beverage center behind
a cabinet door or block the base grille.
" (6.35 mm)
¹⁄₄
4
INSTALLATION INSTRUCTIONS
2
" (6.35 cm)
¹⁄₂
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your beverage center into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your Beverage Center be provided. Use
an outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, disconnect the beverage center from
the electrical source. When you have finished, reconnect the
beverage center to the electrical source.
Unpack the Beverage Center
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
■
on the beverage center. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your beverage center.
For more information see "Beverage Center Safety."
Dispose of/recycle all packaging materials.
■