Whirlpool WUR35X24HZ Handbuch für Gebrauch und Pflege - Seite 6
Blättern Sie online oder laden Sie pdf Handbuch für Gebrauch und Pflege für Kühlschrank Whirlpool WUR35X24HZ herunter. Whirlpool WUR35X24HZ 36 Seiten. Under counter refrigerator
Auch für Whirlpool WUR35X24HZ: Handbuch für Gebrauch und Pflege (36 seiten)
Door Closing
Door Closing
Your beverage center has four leveling legs. If your beverage
center seems unsteady or you want the door to close more easily,
adjust the beverage center's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
2.
Move the beverage center into its final location.
3.
Turn the leveling legs to the right to lower the beverage
center or turn the leveling legs to the left to raise it. It may
take several turns of the leveling legs to adjust the tilt of
the beverage center.
NOTE: Having someone push against the top of the
beverage center takes some weight off the leveling legs.
This makes it easier to adjust the leveling legs.
4.
Make sure that the door closes as easily as you like. If not,
tilt the beverage center slightly more to the rear by turning
both front leveling screws to the left. It may take several
more turns, and you should turn both leveling legs the
same amount.
6
Base Grille
Tools Needed: Phillips screwdriver
Remove the Base Grille
1.
Open the beverage center door.
2.
Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the beverage center.
A
3.
Remove the base grille.
Replace the Base Grille
1.
Open the beverage center door.
2.
Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
BEVERAGE CENTER USE
Normal Sounds
Your new beverage center may make sounds that your old one
didn't make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your beverage center is designed to run more efficiently to
■
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor and
fans may cause your beverage center to run longer than
your old one. You may also hear a pulsating or high-pitched
sound from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the flow of refrigerant or items
■
stored inside the beverage center.
As each cycle ends, you may hear a gurgling sound due to the
■
refrigerant flowing in your beverage center.
You may hear water running into the drain pan when the
■
beverage center is defrosting.
You may hear clicking sounds when the beverage center
■
starts or stops running.
B
A
A. Tabs
B. Screws