Whirlpool WED9051YW Installationsanleitung Handbuch - Seite 17

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Trockner Whirlpool WED9051YW herunter. Whirlpool WED9051YW 20 Seiten. Installation guide
Auch für Whirlpool WED9051YW: Handbuch für Gebrauch und Pflege (20 seiten)

Seite drucken

CONNECT INLET HOSES

For non-steam models, skip to "Connect Vent" on page 18.

The dryer must be connected to the cold water faucet using

the new inlet hoses. Do not use old hoses.

Turn cold water off, remove and

replace rubber washer

Turn cold water faucet off and remove washer inlet hose.

Check and see if rubber washer is in the "Y" connector.

Remove old rubber washer from inlet hose and replace

with new rubber washer provided.

Attach short hose and

"Y" connector

Fig. A

If space permits, attach the brass female end of the "Y"

connector to the cold water faucet. See figure A.

If "Y" connector cannot be attached directly to the cold water

faucet, the short hose must be used. See figure B. Attach short

hose to cold water faucet. Screw on coupling by hand until it is

seated on faucet. Then attach "Y" connector to brass male end

of the short hose. Screw on coupling by hand until it is seated

on connector.

Tighten couplings

Using pliers, tighten the couplings with additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to "Y"

connector and tighten couplings

One end of the long hose has a wire mesh strainer inside the

coupling. Attach this end to the "Y" connector. Attach washer

cold inlet hose to other side of "Y" connector. Screw on

coupling by hand until it is seated on connector. Using pliers,

tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to dryer fill

valve and tighten coupling

Fig. B

Attach other end of long hose to fill

valve at bottom of dryer back panel.

Screw on coupling by hand until it

is seated on fill valve connector.

Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.