Whirlpool 36inch Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool 36inch herunter. Whirlpool 36inch 24 Seiten. Range hood 30" and 36" (76.2 cm and 91.4 cm) vented

Seite drucken

It is recommended that the vent system be installed before

hood is installed.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for exhaust vent.

Check your ceiling height and the hood height maximum

before you select your hood.

To avoid damage or dirt, place a thick, heavy covering over

countertop, cooktop, or range.

1. Disconnect power.

2. Determine which venting method to use: roof or wall.

3. Select a flat surface for assembling the range hood. Place

covering over that surface.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

4. If cabinet has recessed bottom, add wood filler strips on each

side. Locate screws to attach filler strips in locations shown.

3" (7.6 cm)

Determine Wiring Hole Location

Cut only one 1¹⁄₄" (3.2 cm) diameter wiring access hole.

See Step 2 for wiring hole location instructions. Either wiring hole

can be used.

1. Determine and clearly mark a vertical centerline on the wall

and cabinet in the area the vent opening will be made.

A. Centerline

INSTALLATION INSTRUCTIONS

Prepare Location

Wood filler strips

(recessed cabinet

bottoms only)

Cabinet

bottom

Wall

2. To wire through top:

Mark a line 7¹⁄₂" (19.0 cm) from the right of the centerline on

the underside of the cabinet. Mark the point on this line that is

2" (5.0 cm) from back wall. Drill a 1¹⁄₄" (3.2 cm) diameter hole

through the cabinet at this point.

7 ¹⁄₂"

(19 cm)

To wire through rear wall:

Mark a line 7¹⁄₂" (19.0 cm) from the right of the centerline on

the underside of the cabinet. Mark the point on this line that

is ³⁄₄" (1.9 cm) from the underside of the cabinet. Drill a

1¹⁄₄" (3.2 cm) diameter hole through the rear wall at this point.

3. Use saber or keyhole saw to cut a 7" (17.8 cm) diameter

opening.

*5"

(12.7 cm)

*From wall, not

cabinet frame

4. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See "Venting Requirements" section.

5. Use caulking to seal exterior wall or roof opening around the

cap.

2" (5.1 cm)

from wall,

not cabinet

frame

Centerline

³⁄₄" (1.9 cm)

7 ¹⁄₂"

(19 cm)

Centerline

7 ¹/₄" (18.4 cm) diam.

cabinet cutouts