Whirlpool UXD8630DYS Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 15
Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool UXD8630DYS herunter. Whirlpool UXD8630DYS 44 Seiten. 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
Auch für Whirlpool UXD8630DYS: Installationsanleitung und Gebrauchs- und Pflegeanleitung (36 seiten), Installation Gebrauchs- und Pflegeanleitung (40 seiten)
Seite drucken
5. Install the left and right undercounter mounting brackets to
the vent box. Slide the keyhole slots over the guide tabs and
push the brackets up to set them in place.
A. Vent box
B. Undercounter mounting bracket
C. Keyhole slots
D. Guide tabs
6. Drill 2 pilot holes through each of the undercounter mounting
brackets into the underside of the countertop. Using 2 screws
(not provided) of the appropriate length, mount the brackets to
the countertop.
IMPORTANT: Select a screw length that will not allow the
screws to go through the countertop when tightened.
B
A. Screws
B. Backsplash
C. Countertop
B
A
C
D
C
A
7. Check that the downdraft vent is level as shown below.
Loosen the lower support leg screws and position the
legs against the cabinet floor.
B
A
A. Downdraft
B. Level
8. Fasten the lower support legs to the cabinet floor with
screws (not provided).
A. Screw (not provided)
9. Tighten the lower support leg screws.
10. Attach the left and right end caps to the vent box. Place the
tab into the mounting slot at each end of the downdraft vent,
as shown, and push down to lock into place.
A. End cap tab
B. Mounting slot
B
A
A
A
B
15