Whirlpool WVW51UC0FS Installationsanweisungen und Gebrauchs- und Pflegeanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanweisungen und Gebrauchs- und Pflegeanleitung für Lüftungshaube Whirlpool WVW51UC0FS herunter. Whirlpool WVW51UC0FS 9 Seiten. Wall‑mount canopy range hood
Auch für Whirlpool WVW51UC0FS: Installationsanleitung und Gebrauchs- und Pflegeanleitung (28 seiten), Installationsanweisungen; Gebrauchs- und Pflegehinweise (28 seiten)

Install Range Hood

NOTE: Remove protective film from range hood and metal filters.

1. Using two or more people, hang range hood on two

mounting screws through the mounting slots on back of

hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket

using (4) 4.2 x 8 mm screws.

2. Measure from the bottom of the air deflector to the bottom

of the hood outlet.

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over

the exhaust outlet from the hood.

7. Reassemble the air deflector to the duct cover

bracket with the four assembly screws.

8. Seal connections with vent clamps.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet