fireStorm I Series Benutzerhandbuch und Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Gebrauchsanweisung für Außenkamin fireStorm I Series herunter. fireStorm I Series 12 Seiten.

Seite drucken
L I G H T I N G I N ST RU CT I O N S
TURNING ON FIRE FEATURE
1.
Confi rm that the knob on the LP tank has been fully
turned to the open position.
2.
Press Control knob and turn counterclockwise to the
Pilot position.
3.
Using a BBQ Lighter, ignite the lighter and place
next to the jet closest to the thermocouple. [Photo
L1]
4.
Fully depress the Control knob.
5.
Once burner is lit, keep the Control knob pressed in
for 15 - 20 seconds. Burner should remain lit.
Tip: If you release the Ignition Button and the FIRESTORM unit turns off, start
the lighting process again and hold down the ignition button for the full 20
seconds.
Once pilot is lit, press the Control knob in and turn counterclockwise to achieve desired fl ame height.
6.
7.
If burner does not light, turn Control knob to OFF position. Wait 3-5 minutes before repeating lighting process.
TURNING OFF FIRE FEATURE
To safely turn off the FIRESTORM unit:
1.
Slightly push in the Ignition button and while depressed, turn the Ignition Button to the OFF position. Verify fl ame
is out.
WARNING:
DO NOT MOVE THE FIRESTORM WHILE IT IS IN OPERATION. TURN OFF THE APPLIANCE AND ALLOW IT TO
COOL TO THE TOUCH AT LEAST 20 MINUTES BEFORE HANDLING OR MOVING. ALTERATIVELY, TURN OFF
THE APPLIANCE AND HANDLE WITH HEAT RESISTANT GLOVES.
2.
If using a LP tank, turn tank to CLOSED position by turning the tank counterclockwise.
3.
Once the unit is cool, remove Quick-Connect Socket from FIRESTORM, and remove hose connector from LP tank
valve.
4.
Once FIRESTORM is cool to the touch, it is safe to place unit back in provided storage bag or break the unit down.
5.
Do not place the FIRESTORM in a vehicle or enclosed space until it has cooled.
WARNING:
Ensure that no parts of your body, clothing, or any other combustible material are above the burner before, during,
and after ignition.
DISASSEMBLING THE FIRE FEATURE
Once the unit is cool, take the following steps to disassemble:
1.
Remove Burner Insert from unit and set aside.
2.
Starting with one front/back and side panel, unclip latches.
C O O K I N G I N ST RU CT I O N S
If cooking with the FIRESTORM, pan or griddle must be supported and at least 4" above the plate. Do not allow grease or
cooking liquids to drip onto the burner as they may clog jets creating a dangerous condition.
www.GoLiveOutdoor.com | (720) 679-9800 | [email protected]
Photo L1: Lighting Jet Nearest Thermocouple
9