Ergo EMPRO-WM175B Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Racks & Ständer Ergo EMPRO-WM175B herunter. Ergo EMPRO-WM175B 13 Seiten. Flat panel swing out arm

Seite drucken

Adaptor Plate Installation

NB. The adaptor plates can be used with mounting

patterns from 200mm x 200mm to 650mm x

840mm.

NB. In the event that your fl at panel has recessed or

an uneven mounting surface, universal spacers may

Adaptor Plate

be stacked to achieve proper spacing. Select the

amount og universal spacer that is closest in depth

Griplate™

to keep your adaptor plate as close to the fl at panel

Mounting Hardware

as possible. The universal spacer must be secured

between the fl at panel and the adaptor plates.

Flat Panel

Do not overtighten the screws.

Determine if your fl at panel will need the adaptor

plates.

Locate the mounting points on the back of the fl at

panel.

Using a screwdriver, insert and tighten the mounting

hardware and adaptor plates to the back of the fl at

panel. Do not overtighten the screws.

Place the universal mounting brackets over the

threaded mounting studs that are on the adaptor

plate.

Place one 5/16" fl at washer onto each threaded

mounting stud.

Thread one M8 nylon nut onto each threaded

Adaptor Plate

mounting stud.

Socket Wrench

NB. Before tightening the nylon nut, be sure that

both universal mounting brackets are level and

Nylon Nut

aligned with each other. If they are not aligned

and level, the fl at panel will not sit properly when

Flat Washer

mounted to the EMPRO-WM175B.

Universal Mounting

Bracket

Once the universal mounting brackets are level, use a

1/2" socket and socket wrench to tighten the M8 nylon

nuts. Do not over-tighten the screws.