Yamaha TP-7300Rseries Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrument Yamaha TP-7300Rseries herunter. Yamaha TP-7300Rseries 14 Seiten. Pedal timpani
Seite drucken
Initial Preparation
Your Yamaha timpani are equipped with a plastic head carefully mounted and adjusted at the
factory. However, new heads tend to stretch during shipping and storage, so it may be neces-
sary to re-tune the instrument before using. Before playing the pedal timpani for the first time
after purchase, please follow the procedure below and make sure that the head is properly
adjusted.
1
The area between the bearing edge and the
inner circle of the counter hoop is called the
collar. Please make sure that the width of this
collar is uniform, as shown in the illustration
titled "Correct" .
Correct
Bearing
Counter Hoop
edge
Collar
If collar width is not uniform, fully depress the
heel end of the pedal. While holding the pedal
in this position, realign the head and hoop as
shown in the "Correct" illustration.
Caution
Never place your fingers or feet into the
spaces underneath the pedal, the base
portion of the instrument, or between
moving parts such as the casters. Serious
injury can result if fingers or feet become
pinched.
Attaching the Key/Wrench Holder
The attachment plate located on the side of the timpani op-
posite of the tuning indicator is for attaching the key/wrench
holder, which holds the timpani tuning key and hex wrench.
When relocating the key/wrench holder to the opposite side
of the timpani, remove the four bolts using the supplied hex
wrench, then attach using the bolts as shown in the figure
on the right.
18
Wrong
Bearing
Counter Hoop
edge
Collar
2
Fully depress the heel end of the pedal. While
holding the pedal in this position, use the sup-
plied timpani tuning key to tighten the tension
rods one by one ¼ of a turn (90°) in the order
shown in the illustration below.
It is very important that all tension rods be
turned the same amount.
Timpani Tuning Key
26" , 27" , 29" , 32"
Bolts
20" , 23" , 24"
Key/Wrench Holder
Allen Wrench
Timpani
Tuning Key