Yamaha TP-7300Rseries 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Yamaha TP-7300Rseries에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha TP-7300Rseries 14 페이지. Pedal timpani

페이지 인쇄

Initial Preparation

Your Yamaha timpani are equipped with a plastic head carefully mounted and adjusted at the

factory. However, new heads tend to stretch during shipping and storage, so it may be neces-

sary to re-tune the instrument before using. Before playing the pedal timpani for the first time

after purchase, please follow the procedure below and make sure that the head is properly

adjusted.

The area between the bearing edge and the

inner circle of the counter hoop is called the

collar. Please make sure that the width of this

collar is uniform, as shown in the illustration

titled "Correct" .

Correct

Bearing

Counter Hoop

edge

Collar

If collar width is not uniform, fully depress the

heel end of the pedal. While holding the pedal

in this position, realign the head and hoop as

shown in the "Correct" illustration.

Caution

Never place your fingers or feet into the

spaces underneath the pedal, the base

portion of the instrument, or between

moving parts such as the casters. Serious

injury can result if fingers or feet become

pinched.

Attaching the Key/Wrench Holder

The attachment plate located on the side of the timpani op-

posite of the tuning indicator is for attaching the key/wrench

holder, which holds the timpani tuning key and hex wrench.

When relocating the key/wrench holder to the opposite side

of the timpani, remove the four bolts using the supplied hex

wrench, then attach using the bolts as shown in the figure

on the right.

Wrong

Bearing

Counter Hoop

edge

Collar

Fully depress the heel end of the pedal. While

holding the pedal in this position, use the sup-

plied timpani tuning key to tighten the tension

rods one by one ¼ of a turn (90°) in the order

shown in the illustration below.

It is very important that all tension rods be

turned the same amount.

Timpani Tuning Key

26" , 27" , 29" , 32"

Bolts

20" , 23" , 24"

Key/Wrench Holder

Allen Wrench

Timpani

Tuning Key