Clarke CIWLI300 Betriebs- und Wartungsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Elektrowerkzeug Clarke CIWLI300 herunter. Clarke CIWLI300 17 Seiten.

BATTERY CHARGING

The battery will have been shipped in a low charge state and will require charg-

ing before use.

1. Squeeze the battery release clips

on either side of the battery pack

and pull gently down to

disengage the battery pack from

the wrench as in Fig 1.

2. Plug the charger into a 230V

power supply and switch ON.

• The green POWER ON light will

illuminate to show the unit is

connected to the mains supply.

3. Insert the battery pack into the

battery charger, as shown in Fig 2,

noting that it will only fit one way.

• The red light will come on to

indicate the battery is charging.

• When charging is complete

(typically after about 1 hour),

the GREEN charging light comes

on. The battery pack can be

considered charged and be

removed. The charging time will

be dependant upon the initial

state of the battery.

• When charging a new battery

pack it may initially not accept

full charge. This is common & does not indicate a fault. It can be

recharged fully after it has been discharged a couple of times.

• If charging does not take place, ensure all connections are clean.

4. After charging, switch off and unplug the charger from the power supply.

5. Remove the battery pack from the charger and slide it back into the

impact wrench until it clips into place.

The battery pack should slide in easily. If the battery pack is not to be fitted

immediately, ensure that the metal contacts are protected so as to avoid the

possibility of a short circuit which would cause damage. For maximum battery

life, we recommend that you maintain the battery in a fully charged state at

all times.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]