Clarke CIWLI300 Инструкции по эксплуатации и техническому обслуживанию - Страница 8
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Электроинструмент Clarke CIWLI300. Clarke CIWLI300 17 страниц.
Печатать страницу
BATTERY CHARGING
The battery will have been shipped in a low charge state and will require charg-
ing before use.
1. Squeeze the battery release clips
on either side of the battery pack
and pull gently down to
disengage the battery pack from
the wrench as in Fig 1.
2. Plug the charger into a 230V
power supply and switch ON.
• The green POWER ON light will
illuminate to show the unit is
connected to the mains supply.
3. Insert the battery pack into the
battery charger, as shown in Fig 2,
noting that it will only fit one way.
• The red light will come on to
indicate the battery is charging.
• When charging is complete
(typically after about 1 hour),
the GREEN charging light comes
on. The battery pack can be
considered charged and be
removed. The charging time will
be dependant upon the initial
state of the battery.
• When charging a new battery
pack it may initially not accept
full charge. This is common & does not indicate a fault. It can be
recharged fully after it has been discharged a couple of times.
• If charging does not take place, ensure all connections are clean.
4. After charging, switch off and unplug the charger from the power supply.
5. Remove the battery pack from the charger and slide it back into the
impact wrench until it clips into place.
The battery pack should slide in easily. If the battery pack is not to be fitted
immediately, ensure that the metal contacts are protected so as to avoid the
possibility of a short circuit which would cause damage. For maximum battery
life, we recommend that you maintain the battery in a fully charged state at
all times.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8