Directed DBALL-GM10 XPRESSKIT Kurzreferenz-Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Kurzreferenz-Handbuch für Autoalarm Directed DBALL-GM10 XPRESSKIT herunter. Directed DBALL-GM10 XPRESSKIT 16 Seiten.

Seite drucken
Platform: DBALL
Firmware: GM10 v. 2.08+

Installation with T-Harness

(for all GM10 vehicles)
Use connectors
labeled GM10
To Theft Deterrent Module (TDM)
(under ignition switch,
black connector)
Ignition
Barrel
T-01
to vehicle
6-pin connector
T-02
A
* If the RAP OFF wire is not connected, the radio will turn OFF but some lights will remain ON in the central console for 10 minutes. Connect this wire
(Green/Black, pin 2/12) to the driver door sense trigger (Gray/Black) to avoid the issue.
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
(-) Ground
(+) 12v
GM10
Ignition
2: Green/Black: (-) RAP OFF *
Connector
(-) Driver
Door Sense
Trigger*
NOT USED
Yellow
(On the Camaro and Cruze vehicles)
Clutch Switch
(black connector)
For manual
B
C
transmission
vehicles only.
(-) Hood Status Input
(-) Ground
(+) 12v
(+) Ignition Output
3
Theft
GM10
Deterrent
Module (TDM)
connector
Vehicle side
1
Pink: Ignition Output.
Black/White: NC
8: Purple/Brown: N.C.
9: Purple/Green: N.C.
T-Harness
THGM610
(Optional)
Cut away the 4-pin
connector and connect
the three wires to the
OBDII 16-pin connector.
Light Switch
Connector
(-) Parking Lights
Refer to the Vehicle
Wiring Reference Chart
(pages 4, 5, 6, and 8) for
6
1
wire color and location.
12
7
(-) Parking Lights
White/Black: N.C.
Remote Start Safety
Override Switch
(+) 12v
RF
RX
Programming button
(-) Ground
DBALL
LED
TX
NOT USED
Can HIGH
Tan/Black or Blue: pin 6
SW CAN Lt. Green: pin 1
1
9
Can LOW
Tan or White: pin 14
Diagnostic connector
OBDII (connector side view)
© 2012 Directed. All rights reserved.
Rev.: 20130304
Page 9
8
16