Directed DBALL-GM10 XPRESSKIT Quick Reference Manual - Page 9

Browse online or download pdf Quick Reference Manual for Car Alarm Directed DBALL-GM10 XPRESSKIT. Directed DBALL-GM10 XPRESSKIT 16 pages.

Print Page

Platform: DBALL

Firmware: GM10 v. 2.08+

Installation with T-Harness

(for all GM10 vehicles)

Use connectors

labeled GM10

To Theft Deterrent Module (TDM)

(under ignition switch,

black connector)

Ignition

Barrel

T-01

to vehicle

6-pin connector

T-02

* If the RAP OFF wire is not connected, the radio will turn OFF but some lights will remain ON in the central console for 10 minutes. Connect this wire

(Green/Black, pin 2/12) to the driver door sense trigger (Gray/Black) to avoid the issue.

Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.

(-) Ground

(+) 12v

GM10

Ignition

2: Green/Black: (-) RAP OFF *

Connector

(-) Driver

Door Sense

Trigger*

NOT USED

Yellow

(On the Camaro and Cruze vehicles)

Clutch Switch

(black connector)

For manual

transmission

vehicles only.

(-) Hood Status Input

(-) Ground

(+) 12v

(+) Ignition Output

Theft

GM10

Deterrent

Module (TDM)

connector

Vehicle side

Pink: Ignition Output.

Black/White: NC

8: Purple/Brown: N.C.

9: Purple/Green: N.C.

T-Harness

THGM610

(Optional)

Cut away the 4-pin

connector and connect

the three wires to the

OBDII 16-pin connector.

Light Switch

Connector

(-) Parking Lights

Refer to the Vehicle

Wiring Reference Chart

(pages 4, 5, 6, and 8) for

wire color and location.

(-) Parking Lights

White/Black: N.C.

Remote Start Safety

Override Switch

(+) 12v

Programming button

(-) Ground

DBALL

LED

NOT USED

Can HIGH

Tan/Black or Blue: pin 6

SW CAN Lt. Green: pin 1

Can LOW

Tan or White: pin 14

Diagnostic connector

OBDII (connector side view)

Rev.: 20130304

Page 9