Directed DBALL-GM10 XPRESSKIT Quick Reference Manual - Page 10

Browse online or download pdf Quick Reference Manual for Car Alarm Directed DBALL-GM10 XPRESSKIT. Directed DBALL-GM10 XPRESSKIT 16 pages.

Print Page
Platform: DBALL
Firmware: GM10 v. 2.08+

Module Programming

Refer to the LED Diagnostics section for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the XKLoader2.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
"The flashing is successfully completed. You may now unplug the kit."
You can now proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin
and 14-pin harnesses to the module, then connect the 4-pin
D2D harness.
1
OR
W2W Installation
If required for your installation, connect the 10-pin and 12-pin
harnesses to the module, then connect the 14-pin harness to
the module.
The LED turns ON solid red.
2
Make sure the driver's door is open.
Press the Unlock button on the OEM remote and wait until the
3
LED starts to flash orange.
4
Steps 5 to 7 must be executed within 5 seconds.
Turn the key to the IGN position. The LED will start to flash green.
5
Remove the key from the ignition barrel. The LED will keep flashing green.
Insert and turn the key back to the IGN position. The LED will
6
change to solid green for 3 sec. then OFF.
7
Remove the key from the ignition.
rd
3
th
4
st
2
1
rd
3
st
2
1
Press
Unlock button
Key IN
Key OUT
Key IN
Key OUT
© 2012 Directed. All rights reserved.
Rev.: 20130304
Page 10
nd
nd
Solid
&
Flashes
&
START
Flashes
&
START
Flashes
&
START
Solid
START