Clarke METALWORKER CDP15F Betriebs- und Wartungsanleitung - Seite 15
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Elektrowerkzeug Clarke METALWORKER CDP15F herunter. Clarke METALWORKER CDP15F 19 Seiten. 12 speed drill press
Seite drucken
TROUBLE SHOOTING
PROBLEM
Noisy operation
(under load)
Excessive
drill wobble
Motor won't start
Drill binds
in workpiece
Drill burns
or smokes
Table difficult to
raise
PROBABLE CAUSE
A) Incorrect belt tension
B) Dry spindle
C) Loose pulley
D) Loose belt
E) Worn bearing
A) Loose chuck
B) Worn spindle, or bearing
C) Worn chuck
D) Bent drill
A) Power supply
B) Motor connection
C) NVR Switch connections
D) Faulty switch
E) Motor windings burned
F) Pulley Cover not closed.
G) Micro Switch inoperative
A) Excessive feed pressure
B) Loose belt
C) Loose drill
D) Incorrect drill speed.
E) Drill angles incorrect for
type of material
F) Loose Spindle Pulley
A) Incorrect speed.
B) Chips are not discharging
C) Dull drill or incorrect
clearance for material
D) Needs coolant
E) Excessive feed pressure
A) Needs lubrication
B) Table lock tightened
15
REMEDY
A) Adjust tension
B) Remove spindle/quill assembly
and lubricate
C) Tighten pulley
D) Adjust belt tension
E) Replace bearing
A) Tighten by pressing chuck down on
to a block of wood against table.
B) Replace spindle shaft or bearing
C) Replace chuck
D) Renew Drill
A) Check power cord/fuse
B) Check motor connections
C) Check switch connections
D) Replace switch
E) Replace motor
F) Close pulley cover
G) Check operation of micro switch,
per instructions Page 10. If switch
operates correctly but motor fails
to start consult your Clarke dealer
A) Apply less pressure
B) Check belt tension
C) Tighten drill with key
D) Refer to Cutting Speed chart, and
adjust drill speed accordingly
E) Consult an appropriate manual
re. Drills and Cutting Angles, and
sharpen drill accordingly
F) Tighten Pulley grub screw
A) Refer to Cutting Speed chart,
and adjust drill speed accordingly
B) Clean drill
C) Check sharpness & profile
D) Use coolant whilst drilling
E) Apply less pressure
A) Lubricate with light oil
B) Loosen clamp