Zanussi FJ 1200 Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Waschmaschine Zanussi FJ 1200 herunter. Zanussi FJ 1200 22 Seiten. Zanussi washing machine instruction manual
Auch für Zanussi FJ 1200: Gebrauchsanweisung (25 seiten)

Seite drucken

INSTALLATION

Unpacking

Before starting the machine up, the packing must be

removed as follows.

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

Unscrew and remove the

rear right bolt (using a

spanner).

Lay the ma-

chine gently on its back,

making

sure

that the

hoses are not squashed.

Remove the polystyrene block from the bottom of the

machine.

Carefully slide out the right polythene bag (1), removing

it toward the centre of the machine.

Repeat the operation for the left polythene bag (2),

removing it toward the centre of the machine.

Remove the polystyrene

base, set the machine

upright and unscrew the

two remaining rear bolts.

Slide out the 3 plastic spacers and plug the 3 holes with

the 3 plastic plugs which you find at the back of the

machine.

Positioning

Your new Zanussi washing machine has been designed

to be permanently plumbed in to your home's water

supply and drainage system. However,

if this is not

possible, it may be connected to suitable existing taps,

with the drain hose discharging into a sink.

The appliance has two inlet hoses, hot and cold, with

female %" BSP thread connectors. If this connection is

not compatible with the plumbing

of the existing

installation, a variety of connectors are available from

good hardware stores and plumbers merchants to suit

most domestic plumbing. Any alterations to your existing

plumbing must be carried out by a competent person, or

qualified plumber.

Water inlet

The inlets on the back of the appliance are colour coded,

blue for cold and red for hot.

Before

connecting

the

hoses be sure to fit the

mesh filters supplied as

per diagram.

If only a cold water supply is available, connect the two

hoses to a cold water outlet by means

of a 'Y'

connection piece.

Installation should comply with local water authority and

building regulations' requirements.

The appliance must be given a separate cold water

supply and not be connected to a mixer tap, a single

outlet water heater or a booster pump. A minimum water

pressure of 7psi is required for safe operation of the

appliance.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system.

There should be a minimum distance of 5.02m (16 'ft)

between the appliance's inlet and the bottom of the tank.

There will be sufficient pressure for the hot water supply

from the hot water cylinder if the height between the

appliance's inlet and the bottom of the cold water

storage cistern (not between

the appliance and hot

water cylinder) is at least 2.74m (9ft).

Set the hoses correctly by

loosening the ring nuts.

After positioning the inlet

hoses, be sure to tighten

the ring nuts again to

prevent leaks.