Zanussi FJ 1200 Буклет с инструкциями - Страница 4
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Стиральная машина Zanussi FJ 1200. Zanussi FJ 1200 22 страницы. Zanussi washing machine instruction manual
Также для Zanussi FJ 1200: Буклет с инструкциями (25 страниц)
Печатать страницуINSTALLATION
Unpacking
Before starting the machine up, the packing must be
removed as follows.
You are advised to keep all the packaging for re-use in
case the machine is to be transported again.
Unscrew and remove the
rear right bolt (using a
spanner).
Lay the ma-
chine gently on its back,
making
sure
that the
hoses are not squashed.
Remove the polystyrene block from the bottom of the
machine.
Carefully slide out the right polythene bag (1), removing
it toward the centre of the machine.
Repeat the operation for the left polythene bag (2),
removing it toward the centre of the machine.
Remove the polystyrene
base, set the machine
upright and unscrew the
two remaining rear bolts.
Slide out the 3 plastic spacers and plug the 3 holes with
the 3 plastic plugs which you find at the back of the
machine.
Positioning
Your new Zanussi washing machine has been designed
to be permanently plumbed in to your home's water
supply and drainage system. However,
if this is not
possible, it may be connected to suitable existing taps,
with the drain hose discharging into a sink.
The appliance has two inlet hoses, hot and cold, with
female %" BSP thread connectors. If this connection is
not compatible with the plumbing
of the existing
installation, a variety of connectors are available from
good hardware stores and plumbers merchants to suit
most domestic plumbing. Any alterations to your existing
plumbing must be carried out by a competent person, or
qualified plumber.
Water inlet
The inlets on the back of the appliance are colour coded,
blue for cold and red for hot.
Before
connecting
the
hoses be sure to fit the
mesh filters supplied as
per diagram.
If only a cold water supply is available, connect the two
hoses to a cold water outlet by means
of a 'Y'
connection piece.
Installation should comply with local water authority and
building regulations' requirements.
The appliance must be given a separate cold water
supply and not be connected to a mixer tap, a single
outlet water heater or a booster pump. A minimum water
pressure of 7psi is required for safe operation of the
appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum distance of 5.02m (16 'ft)
between the appliance's inlet and the bottom of the tank.
There will be sufficient pressure for the hot water supply
from the hot water cylinder if the height between the
appliance's inlet and the bottom of the cold water
storage cistern (not between
the appliance and hot
water cylinder) is at least 2.74m (9ft).
Set the hoses correctly by
loosening the ring nuts.
After positioning the inlet
hoses, be sure to tighten
the ring nuts again to
prevent leaks.