aerauliqa QCmev80 Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Klimageräte aerauliqa QCmev80 herunter. aerauliqa QCmev80 17 Seiten.

Seite drucken

Installation manual

QCmev 80 and QCmev125 - Whole house mechanical extract fan

Read this manual carefully before using the product and

keep it in a safe place for reference.

This product was constructed up to standard and in

compliance w ith r egulations r elating t o e lectrical e quipment

and must be installed by technically qualified personnel.

The manufacturer assumes no responsibility for damage to

persons or property resulting from failure to observe the

regulations contained in this booklet.

PRECAUTIONS FOR INSTALLATION, USE ANd MAINTENANCE

• T he device should not be used for applications other than those speciﬁed in this manual.

• A fter removing the product from its packaging, verify its condition. In case of doubt,

contact a qualiﬁed technician. Do not leave packaging within the reach of small children

or people with disabilities.

• D o not touch the appliance with wet or damp hands/feet.

• T his appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge

if they have been given supervision or instruction concerning use of the appliance

in a safe way and understand the hazards involved. Children shall not play with the

appliance.

Cleaning and user maintenance shall not be made by children without supervision.

• D o not use the product in the presence of flammable vapours, such as alcohol,

insecticides, gasoline, etc...

• I f any abnormalities in operation are detected, disconnect the device from the mains

supply and contact a qualiﬁed technician immediately. Use original spare parts only for

repairs.

• T he electrical system to which the device is connected must comply with regulations.

• B efore connecting the product to the power supply or the power outlet, ensure that:

- the data plate (voltage and frequency) correspond to those of the electrical mains

- the electrical power supply/socket is adequate for maximum device power. If not,

contact a qualiﬁed technician.

• T he device should not be used as an activator for water heaters, stoves, etc., nor

should it discharge into hot air/fume vent ducts deriving from any type of combustion

unit. It must expel air outside via its own special duct.

• O perating temperature: 0°C up to +40°C.

• T he device is designed to extract clean air only, i.e. without grease, soot, chemical or

corrosive agents, or flammable or explosive mixtures.

• D o not leave the device exposed to atmospheric agents (rain, sun, snow, etc.).

• D o not immerse the device or its parts in water or other liquids.

• T urn off the main switch whenever a malfunction is detected or in case of cleaning/

maintenance.

• F or installation an omnipolar switch should be incorporated in the ﬁxed wiring, in

accordance with the wiring regulations, to provide a full disconnection under overvoltage

category III conditions (contact opening distance equal to or greater than 3mm).

• I f the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualiﬁed persons in order to avoid a hazard.

Fig. 1