Clarke CMS 200 Betriebs- und Wartungsanleitung - Seite 12
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Sander Clarke CMS 200 herunter. Clarke CMS 200 18 Seiten. 3 in1 multi sander
Auch für Clarke CMS 200: Handbuch für Betrieb und Wartung (17 seiten)
Seite drucken
C. Straight Bevel Cutting
As with Mitre Cutting, this is a cross cutting operation, except that the
blade is not perpendicular to the table, (see fig. 6).
Ensure the table is set so that the
mark (J), on the edge of the
table, lines up with the zero on
the scale on the bed.
The 45° adjuster is factory set so
that when the Head is tilted to
its fullest extent the blade will cut
a perfect 45° bevel.
If however you require any other
angle, you should proceed as
follows:
Cut a mitre of the required
angle, on a spare piece of
wood, and use this as a
template for your bevel cut.
Fig.7
switch G, wait for full speed to develop, then lower the blade to the
workpiece.
D. Compound Mitre and Bevel Cutting.
Having determined the angles you require, firstly set the bevel angle, using
the procedure described above, and then the mitre angle.
NOTE: Compound mitre and bevel cuts, at a full 45°, can only be made
when the head is turned to the left.
The procedure for cutting is the same as that for cross cutting.
Slacken off the Bevel Locking Nut (C,
fig.7), using the box spanner
provided, and swing the Head to the
side. Lower the arm, and bring your
template up to the saw blade. When
satisfied that the edge of template
and blade are parallel, lock the
head in position with lock nut (C).
Your angle is now set.
The procedure for cutting is the same
as that for cross cutting....press start
12
Fig.6