Clarke CMS 200 운영 및 유지 관리 지침 - 페이지 12

{카테고리_이름} Clarke CMS 200에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMS 200 18 페이지. 3 in1 multi sander
Clarke CMS 200에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)

페이지 인쇄

C. Straight Bevel Cutting

As with Mitre Cutting, this is a cross cutting operation, except that the

blade is not perpendicular to the table, (see fig. 6).

Ensure the table is set so that the

mark (J), on the edge of the

table, lines up with the zero on

the scale on the bed.

The 45° adjuster is factory set so

that when the Head is tilted to

its fullest extent the blade will cut

a perfect 45° bevel.

If however you require any other

angle, you should proceed as

follows:

Cut a mitre of the required

angle, on a spare piece of

wood, and use this as a

template for your bevel cut.

Fig.7

switch G, wait for full speed to develop, then lower the blade to the

workpiece.

D. Compound Mitre and Bevel Cutting.

Having determined the angles you require, firstly set the bevel angle, using

the procedure described above, and then the mitre angle.

NOTE: Compound mitre and bevel cuts, at a full 45°, can only be made

when the head is turned to the left.

The procedure for cutting is the same as that for cross cutting.

Slacken off the Bevel Locking Nut (C,

fig.7), using the box spanner

provided, and swing the Head to the

side. Lower the arm, and bring your

template up to the saw blade. When

satisfied that the edge of template

and blade are parallel, lock the

head in position with lock nut (C).

Your angle is now set.

The procedure for cutting is the same

as that for cross cutting....press start

Fig.6