Clarke COBS1 Handbuch für Betrieb und Wartung - Seite 9
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Sander Clarke COBS1 herunter. Clarke COBS1 17 Seiten. Oscillating bobbin sander
Seite drucken
SETUP
1. Put the support washer on the
spindle.
• Grooved side must face up.
2. Slide the bobbin on to the spindle.
3. Secure the bobbin using the
correct washer, and nut supplied.
• Use the largest washer that
does not overlap the edge of
the sanding sleeve.
4. Do not tighten the nut fully yet.
5. Put the correct table insert into
place as shown and tighten up
the nut on top of the bobbin.
• The table insert must be used at
all times
• If the table insert is damaged It
must be replaced before use.
Spare parts are available from
the Clarke spare parts
department.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9