Clarke COBS1 Instrukcja obsługi i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sander Clarke COBS1. Clarke COBS1 17 stron. Oscillating bobbin sander

SETUP

1. Put the support washer on the

spindle.

• Grooved side must face up.

2. Slide the bobbin on to the spindle.

3. Secure the bobbin using the

correct washer, and nut supplied.

• Use the largest washer that

does not overlap the edge of

the sanding sleeve.

4. Do not tighten the nut fully yet.

5. Put the correct table insert into

place as shown and tighten up

the nut on top of the bobbin.

• The table insert must be used at

all times

• If the table insert is damaged It

must be replaced before use.

Spare parts are available from

the Clarke spare parts

department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]