Clarke CSD4 Handbuch für Betrieb und Wartung - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Water Pump Clarke CSD4 herunter. Clarke CSD4 13 Seiten. Multistage submersible pump
Seite drucken
• The water inlet must be fully submerged before the pump is switched on
and the pump be standing upright.
5. Connect the power cable to a high sensitivity residual current device
(RCD) which has a tripping current of less then 30mA.
OPERATING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
1. Switch the mains power supply on.
• The pump will begin to drain water until it reaches the 12 mm limit.
2. When finished, disconnect the pump from the power supply.
CAUTION: DO NOT ALLOW THE PUMP TO RUN DRY
• The pump is fitted with a thermal overload switch. If the pump overheats
for any reason, it will automatically switch the pump OFF. Once the
pump has cooled (at least 5-10 minutes), it will automatically restart.
AFTER USE
If the temperature is expected to be lower than 0°C, ensure there is no residual
water in the pump which could freeze and damage the pump.
If the pump has been used with substances that tend to form a deposit, or
with water containing chlorine, rinse it after use with a powerful jet of water in
order to avoid the formation of deposits which would reduce the
performance of the pump.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7