Clarke CSD4 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CSD4에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSD4 13 페이지. Multistage submersible pump

• The water inlet must be fully submerged before the pump is switched on

and the pump be standing upright.

5. Connect the power cable to a high sensitivity residual current device

(RCD) which has a tripping current of less then 30mA.

OPERATING THE PUMP

WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE

PUMP IF IT IS DAMAGED IN ANY WAY.

1. Switch the mains power supply on.

• The pump will begin to drain water until it reaches the 12 mm limit.

2. When finished, disconnect the pump from the power supply.

CAUTION: DO NOT ALLOW THE PUMP TO RUN DRY

• The pump is fitted with a thermal overload switch. If the pump overheats

for any reason, it will automatically switch the pump OFF. Once the

pump has cooled (at least 5-10 minutes), it will automatically restart.

If the temperature is expected to be lower than 0°C, ensure there is no residual

water in the pump which could freeze and damage the pump.

If the pump has been used with substances that tend to form a deposit, or

with water containing chlorine, rinse it after use with a powerful jet of water in

order to avoid the formation of deposits which would reduce the

performance of the pump.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]