Clarke CSD4 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CSD4에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSD4 13 페이지. Multistage submersible pump

INSTALLING THE PUMP

Remove all packaging and make sure that the pump has no visible damage.

Dispose of all packaging appropriately.

FITTING THE STEPPED ADAPTER

The stepped hose adaptor supplied is designed to be used for either screw

type hose connection or push fit.

• Stepped adapter 1" (25mm) /

1. Screw the adaptor to the

discharge port and connect a

suitable hose (not supplied) to

either the screwed end or push-fit.

• Suitable hoses are available

from your local CLARKE dealer.

• The stepped adaptor can be

cut off with a hacksaw if a

larger hose is to be used.

2. Trim the adaptor to size if required.

• Reducing the hose diameter will affect the maximum flow rate.

3. When push fitting the hose to the adaptor use a jubilee clip to secure it. Do

not overtighten.

1. Stand the pump upright on a flat surface in

the water that you want to drain.

2. If there is sediment in the pool or pond, place

the pump on blocks, to avoid blocking the

water inlet.

3. Ensure the pump is positioned with adequate

space around the inlet and to the maximum

depth of installation shown.

• The pump is supplied with 15 metres of

power cable.

4. Always raise and lower the pump using the

lifting handle and a rope attached to it if

required. Never lift or lower the pump using

the power cable.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

"(20mm) hose