Clarke CSD4 Manuel d'utilisation et d'entretien - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Clarke CSD4. Clarke CSD4 13 pages. Multistage submersible pump
Imprimer la page
INSTALLING THE PUMP
Remove all packaging and make sure that the pump has no visible damage.
Dispose of all packaging appropriately.
FITTING THE STEPPED ADAPTER
The stepped hose adaptor supplied is designed to be used for either screw
type hose connection or push fit.
• Stepped adapter 1" (25mm) /
1. Screw the adaptor to the
discharge port and connect a
suitable hose (not supplied) to
either the screwed end or push-fit.
• Suitable hoses are available
from your local CLARKE dealer.
• The stepped adaptor can be
cut off with a hacksaw if a
larger hose is to be used.
2. Trim the adaptor to size if required.
• Reducing the hose diameter will affect the maximum flow rate.
3. When push fitting the hose to the adaptor use a jubilee clip to secure it. Do
not overtighten.
POSITIONING THE PUMP
1. Stand the pump upright on a flat surface in
the water that you want to drain.
2. If there is sediment in the pool or pond, place
the pump on blocks, to avoid blocking the
water inlet.
3. Ensure the pump is positioned with adequate
space around the inlet and to the maximum
depth of installation shown.
• The pump is supplied with 15 metres of
power cable.
4. Always raise and lower the pump using the
lifting handle and a rope attached to it if
required. Never lift or lower the pump using
the power cable.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
¾
"(20mm) hose
6